Cda CYLINDER EXTRACTORS EVCK4 Instrukcja Użytkownika

EVCK4 Cylinder ExtractorsManual for Installation, Use and MaintenanceCustomer Care Department • The Group Ltd. • Harby Road • Langar

9Mounting your extractor9. Assemble the ventilation duct(H), as shown in the diagrams below dependanyt on whether you are extracting air to the

10Mounting your extractorIMPORTANT NOTE:The extractor is now mounted and secured to the wall; the electrical connections are now required to be made i

Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HYT : 01949 862 012 F : 01949 862 00

ImportantThe manufacturer cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note that

2Using your ExtractorFor best performance, you should switch on the extractor 15 minutes before starting to cook and leave it to run for approximately

3Care and MaintenanceIMPORTANT : DO NOT PERFORM MAINTENANCE OR CLEANING OF THE EXTRACTOR WITHOUT FIRST SWITCHING OFF THE ELECTRICITY SUPPLY.Cleaning Y

4Fig. 5Changing the LightIMPORTANT: DO NOT PERFORM MAINTENANCE OR CLEANING OF THE EXTRACTOR WITHOUT FIRST SWITCHING OFF THE ELECTRICITY SUPPLY.DO NOT

5DOUBLE POLE SWITCHED FUSED SPUR OUTLETUSE A 3 AMP FUSEMains Electricity ConnectionTHIS APPLIANCE MUST BE CONNECTED TO THE MAINS SUPPLY BY A COMPETENT

6InstallationIMPORTANT:The extractor is intended to be mounted directly to the ceiling using fixings appropriate for the ceiling. Ensure that there is

7Mounting your extractor1. Using the supplied template, mark the positions of the 3 main fixing holes and the additional fixing hole (X) on the c

8Mounting your extractor6. When used with a CDA hob, the extractor is required to be 650mm above the hotplates. Measure the height of the ceili