CDA hc7620 Instrukcja Obsługi Pobierz pdf (Strona 7)

To Switch Heating Zones On

When the mains power supply is switched on, the buzzer beeps

once and all the indicators light up for 1 second, then go out. This

indicates that the ceramic hob has entered standby mode.

Touch the ON/OFF control; all the indicators show “-“.

(If you don’t switch a heating zone or the minute minder “On”

within approx. 1 minute, the ceramic hob will automatically switch

off.)

Place a suitable pan on the cooking zone that you wish to use

(see “Efficient Use of Your Hob” section for selection of suitable

pans).

Ensure the bottom of the pan and the surface of the cooking zone

are clean and dry.

Touch either the “+” or “-“ control corresponding to the zone you

wish to switch “On”. (for example back left ).

Select a heat setting by touching the “+” or “-“ controls. You may

select any power level from “1” to “9”.

You can change the heat setting at any time during cooking.

By holding down either of these controls, the power level will

adjust up or down.

To use more than one heating zone, just repeat a similar

procedure for each zone you wish to use (as above).

1 2 3 4 5 6 7 8 9 10 11 12 ... 24 25

Brak uwag

CDA hc7620 Instrukcja Obsługi Strona 7