Cda HVC 32 Instrukcja Użytkownika Pobierz pdf (Strona 20)

Fastening the Cooktop

Each cooktop is supplied with a set of tabs and screws to fasten it on units with a working surface from 2

to 4 cm deep.

The kit includes 4 tabs A and 4 self-threading screws B (fig. 11).

– Cut the unit.

– Turn the hob upside down and rest the glass side on a cloth.

– Spread the seal C around the edge of the hob (fig. 12).

– Put tabs A into the mountings; only tighten screws B a few turns.

Make sure that the tabs are mounted correctly as shown in the figure 11.

– Put the cooktop into the hole cut into the unit and position it correctly.

– Put tabs A into place, tooth D of the tabs should go into the hole.

– Tighten screws B until the cooktop is completely secured.

– Using a sharp tool cut off the part of gasket C which protrudes from the cooktop. Take care not to

damage the workbench.

Fig. 12

Adhesive side

20 mm min.

40 mm max.

Fig. 11

1 2 ... 15 16 17 18 19 20 21 22 23 24

Brak uwag

Cda HVC 32 Instrukcja Użytkownika Strona 20