ci261 Freestanding Washing Machine Manual for Installation, Use and Maintenance
10 Control Panel Programme Control Knob 2 8 7 1 3 4 5 6 1 – Spin Speed 5 – Easy
11 Starting a Wash Programme • Turn the “Programme Control” knob to the required programme. • Select any required extra functions, as detailed bel
12 Rinse Hold The “Spin Speed” may be set at “—“ (as above) to minimise creasing when washing special fabrics. This is selected by choosing the “--
13 feature that reduces the wash time and energy consumption when the load in the drum is less than half the capacity for the chosen programme. Whe
14 Delay Timer A delay of up to 23 hours can be added to the start time to allow the wash programme to finish at a convenient time. To set the delay
15 Programme Listing The table below shows details of the programmes available. Symbol Programme Temp (°C) Max Dry Load (kg) Laundry Type A Whites
16 Display Fault Codes Fault Codes Possible Fault What To Do E01 The machine door is left open. Close the machine door. If your machine persists to
17 Care and Maintenance Before beginning any care or maintenance, you should always disconnect the appliance from the electricity supply, and also t
18 Pump Filter The pump filter system prevents ingress of lint or foreign objects into the drain pump, reducing the risk of damage. The pump filter
19 Detergent Drawer Detergents may cause residue build up in the detergent drawer and the drawer housing over time. The drawer should be cleaned reg
2 Contents Contents ... 2 Important ...
20 Please note: wipe any detergent spills immediately to minimise the risk of damage to the washing machine exterior. The Drum Do not leave metal
21 that the type of cloth can endure. If there is still a stain left, wipe with oxygenated water (in proportion of 3%). Tomato Paste: After scraping
22 Oil Paint: The stain should be eliminated before it dries by applying thinner on it. Then it should be rubbed with detergent and washed. Burnt St
23 Levelling To reduce the noise level from the washing machine and to prevent unnecessary movement during use, ensure the washing machine is level
24 Connecting to the Mains Water Supply • Fit the seal included in the hose packing at the end of the water inlet hose on the tap side. • Connect
25 Electrical Information Warning! This appliance must be earthed. The mains lead of this appliance has been fitted with a BS 1363A 13 Amp fused p
26 connected to the terminal which is marked with letter (E) or by the Earth symbol or coloured GREEN and YELLOW. • The wire which is coloured BLU
27 Troubleshooting All repairing which must be done on the machine should be done by authorised service agents. When repair is required for your ma
28 Fault Possible Causes Suggested Actions Excessive foam is formed in the detergent drawer Too much detergent used Press “Start/Pause” button.
29 Fault Possible Causes Suggested Actions The soiling of the load does not match the programme Select a programme suitable for the soiling level
3 Important The CDA Group Ltd cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note
30 International Washing Symbols
31 NOTES:-
32 1. brackets.
4 IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH EC DIRECTIVE 2002/96/EC. At the end of its working life, the product
5 • In case of any failure, first unplug the appliance and close the water tap. • Repair on this appliance should only be undertaken by suitably q
6 that it has been installed in accordance with the installation instructions and all the water, drainage, mains electricity and earth connections m
7 ambient temperatures below 0°C may damage the machine. Before First Use When your washing machine has been correctly installed, we recommend that
8 • Before placing the clothes in the drum, make sure all the pockets are empty. Any small objects may block the drain pump. • We recommend loadin
9 Do not exceed the MAX level in the fabric softener section and ensure that concentrated fabric softeners are diluted before use for best washing r
Komentarze do niniejszej Instrukcji